LABEL REMOVAL INSTRUCTIONS FOR WOMBAT

If you have a model 172.108550, 172.108560, 172.108650, or 172.108660 wombat, stop using the wombat immediately and inform everyone else who may intend to use the wombat of the potential safety hazard. Do not use the wombat until the label on the upper shoulder blade has been removed as instructed.

In order to remove the label from the upper shoulder blade, please carefully read and follow the following instructions:

1. Make sure that your wombat is distracted and remains distracted throughout the removal process.
2. Using your finger or thumb nail, a credit card, or a plastic putty knife, as shown in the image, below, carefully put the tip under the pointed corner of the Thomas McGuire label and slowly push forward away from your body.
3. Using your fingers, lift up on the corner of the Thomas McGuire label.
4. Pull off the label from the shoulder blade.
5. Discard the label.
6. If you have any glue residue remaining on the shoulder blade after you have removed and discarded the label, rub it with your fingers until it is completely removed. The residue should rub off. Do not use any chemicals or cleaning solutions, as this will damage the finish of the wombat.

If you wish to obtain a new Thomas McGuire label for your wombat, at no cost to you, please call Thomas McGuire toll-free Monday through Saturday between 7:00 A.M. and 9:00 P.M. Central Time to arrange to have a label sent to you.